RHEEM LOLINE® & PREMIER LOLINE®
GROUND MOUNTED SOLAR HOT WATER SYSTEMS
Rheem Loline® and Premier Loline® ground mounted systems have solar collectors on the roof and tanks installed on the ground or at floor level. Choice of a Stainless Steel or Vitreous Enamel lined tanks suitable for all your home requirements from tropical to cold climates.
The water from the tank in a Loline open circuit or direct system is circulated up into the solar collector, where it is heated before returning to be stored in the tank. The Rheem Premier Loline range of closed circuit or indirect systems use a solar heating fluid which is pumped up to the solar collectors before returning to transfer heat gained from the solar collectors to the water in the tank using its advanced technology in the heat exchanger. The Premier Loline range provides full freeze protection and is also suitable for harsh water areas.
The system that is best for you depends on a variety of factors so it’s important to talk to your local Rheem Solar Specialist about the Rheem solar water heater that is right for you.
Rheem Solar Specialists have years of experience and are qualified tradespeople that understand the importance of selling a quality product that is backed by the best after sales service. Call your local Rheem Solar Specialist and ask them about current trade in promotions and solar rebate incentives. Call 1300 786 747 today.
Features at a Glance
- Available in 270L or 325L or 410L tank capacity
- Stainless Steel or Vitreous Enamel lined tanks4,5
- Four Colorbond® colour options
- Full mains pressure from multiple outlets
- Available in Non-Frost or Complete Frost or Enhanced Frost Protected model options
- Cylinder Warranty of 5 or 10 years4,5
- Booster – your choice of an electric element or 6-Star continuous flow gas boost back up, to keep you in hot water when the sun isn’t shining
- Suitable for 1 to 6 people
- Warranty backed by Rheem Australia Pty Ltd
1. Energy reduction is based on Australian Government Approved TRNSYS simulation modelling on each system model using a medium load in Zone 3 and applies when replacing an electric water heater. Electric boost models only.
2. Any financial savings will vary depending upon type of Rheem Solar system installed, orientation and inclination of the solar collectors, type of water heater being replaced, hot water consumption and fuel tariff. Maximum financial savings off your hot water bill are achievable when replacing an electric water heater on continuous tariff.
3. Eligibility criteria apply.
4. Stainless Steel is not suitable for harsh water conditions. Not available in WA and other locations where water chemistry is a limiting factor. Please see suitability maps. Link: www.solar.rheem.com.au/images/Residential_Stainless_Steel_suitability_map_of_Australia_Nov_2019.pdf
5. Warranty Conditions. See the Rheem warranty set out in the Owner’s Guide & Installation Instructions for each model or view at rheem.com.au/warranty Phone 131 031 for details. Materials and specifications correct as on 1st March 2019. Rheem Australia reserves the right to change product specifications without any prior notification.
6. An open or direct system has potable water flowing through the solar collectors.
7. A closed circuit or indirect system has a non-potable solar heating fluid with anti-freeze properties flowing through the solar collectors.
